LIFESTYLER C230 831.287630 Owner's Manual page 4

ASSEMBLY
Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing
materials until assembly is completed. Read all steps carefully before beginning. Use the PART
IDENTIFICATION CHART below to identify the small hardware used in assembly. The number in
parenthesis beneath each part refers to the key number of the part. The second number refers to the
quantity used in assembly. Note: Some of the small hardware may have been pre-attached to one of
the parts to be assembled. If a part is missing, see the back cover of this manual for instructions.
TOOLS REQUIRED FOR ASSEMBLY: The Included tools, end your own hammer and adjustable
wrench.
PART IDENTIFICATION CHART
Pedal Cap (50)-2
9/16" Washer (32)-2
@8 @@
1/4" Seat Nut (7)--4 5/16" x 1/2" Screw (33)-4
5/16" Washer (40)-2
1/2" Nylock Nut (46)-2
5/16" x I 1/4" Bolt (14)--4
@8
5/16" Pedal Nut (49)-2 1/2" Phillips Screw (4)-6
4
1..Raise the back of the exercise bike. Attach the Stabilizer
(t3) to the Frame (11) with the four 5/16" x 1 1/4" Bolts
(14). The Stabilizer must be turned so the ribbed sides of
the Flat Endcaps (12) are on the side shown. Lower the
exercise bike.
2. Press a Round Endcap (54) onto each end of the stabilizer
on the fi'ont of the Frame (11).
12
14- 13
I
54
12
54