LIFESTYLER C230 831.287630 Owner's Manual page 5

3.
Remove the four 1/4" Seat Nuts (7) from the underside of
the Seat (5). Remove the Seat Post (6) from the Frame
(11). Attach the Seat to the top of the Seat Post with the "
four 1/4" Seat Nuts,
Insert the Seat Post (6) into the Frame (11), adjust the
Seat (5) to the desired height, and insert the Seat Pin (8)
through the front of the Frame and the Seat Post. Slide
the Seat Post Collar (30) down over the top of the Frame.
CAUTION: At least two Inches of the Seat Post must
be Inside of the Frame. The Seat Pin must be inserted
from the front, as shown. If the Seat Pin is inserted
from the back, it may slip out, resulting in injury.
t. D i
30_ ;....
4. Attach the Right Handlebar (2) to:the Left Handlebar (9)
with two 112"Phillips Screws (4).
9
5. Attach the Right and Left Handlebars (2, 9) to the plate on
the Frame (11) with the two Handlebar Brackets (53) and
four 5/16" x 112"Screws (33) as shown.
i "
6. The Console (1) requires two "AA" batteries (not
included); alkaline batteries are recommended. Slide open
the battery cover on the front of the Console (see the upper
inset drawing). Find the markings inside the battery clip
showing which directionthe batteries must be turned. Press
the battedes into the battery clip. Close the battery cover.
Attach the wire extending from the Console (1) to the
Sensor Wire (31) (see the lower inset drawing).
Slide the Neck Shield (37) onto the Left and Right Side
Shields (16, 34) as shown. Be careful not to pinch the
cable and wires extending from the Neck Shield.
Attach the Neck Shield to the Handlebar Brackets (53)
with four 1/2" Phillips Screws (4).
5