Tools And Parts - Kenmore 8519320 Use & Care Manual

He3 gas dryer
Table of Contents

Advertisement

Available languages

Available languages

For a garage installation, you will need to place the dryer at
least 18 in. (46 cm) above the floor. If using a pedestal, you
will need an additional 6 in. (15.24 cm).
Do not operate your dryer at temperatures
below 45°F (7°C). At
lower temperatures,
the dryer might not shut off at the end of an
automatic cycle. Drying times can be extended.
The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.
Check code requirements.
Some codes limit, or do not permit,
installation of the dryer in garages, closets, mobile homes, or
sleeping quarters. Contact your local building inspector.
NOTE: No other fuel-burning
appliance can be installed in the
same closet as a dryer.
Installation clearances
The location must be large enough to fully open the dryer door.
Dryer Dimensions
,_=
(1Z.27
¢rn)
* Most installations require a minimum 51/2in. (14 cm) clearance
behind the dryer for the exhaust vent with elbow. See "Venting
Requirements."
Minimum installation
spacing for recessed area, custom
undercounter
or closet installation
The dimensions shown following are for the minimum spacing
allowed.
Additional spacing should be considered for ease of
installation and servicing.
Additional clearances might be required for wall, door and
floor moldings.
Additional spacing of 1 in. (2.5 cm) on all sides of the dryer is
recommended
to reduce noise transfer.
For closet installation, with a door, minimum ventilation
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are
acceptable.
Companion appliance spacing should also be considered.
Custom undercounter
installation
- Dryer only
0 u
(0
cm)
/
38" mitt
(96.S2 c rn)
0 II
_
27
II
i
0 II
Closet installation
- Dryer only
in.z
lOcrn 2)
LI
Cffl 2)
10._
3t_'.
o'
(oe-_)(8&01_) (8era)
1
2
1. Side view - closet or confined area
2. Closet door with vents
3,,
(7.e am)
3"
.6cm)
Recessed or closet installation
- Dryer on pedestal
O"
27"
0"
(o_)-_(eu
_r.)_(O
_m)
1
t4" m_x
(35.6
I 0.1< 31_ >1 0"
(Ocm) ( 80.01crn) (Ocrn)
2
1, Recessed area
2. Side view - closet or confined area
Mobile home-additional
installation
requirements
This dryer is suitable for mobile home installations.
The installation must conform to the Manufactured
Home
Construction
and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD Part 280).
Mobile home installations
require:
Metal exhaust system hardware which is available for
purchase from your local Sears store or Sears Service Center.
Mobile home Installation Kit Part Number 346764. See "Tools
and Parts" section for ordering information.
Special provisions must be made in mobile homes to
introduce outside air into the dryer. The opening (such as a
nearby window) should be at least twice as large as the dryer
exhaust opening.
6

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

110 series

Table of Contents