Installation Requirements; Tools And Parts - Kenmore 11078103310 Installation Instructions Manual

iNSTALLATiON REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed:
#2 Phillips screwdriver
Flat-blade screwdriver
Parts supplied (all models):
Leveling legs (4) for models
with riser
Leveling legs (4) for models
without riser
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Wire stripper (direct wire
installations)
{i® @ ®]
Level
(D
Vent clamps
Parts supplied (steam models):
Short inlet hose
5' (1.52 m) inlet hose Rubber washer
Caulking gun and
compound (for installing
new exhaust vent)
Tin snips (new vent
installations)
Parts package is located in dryer drum. Check that all parts
are included.
Parts needed: (Not supplied with dryer)
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements" before
purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, please refer to the "Assistance
or Service" section in your "Use and Care Guide."
Optional Equipment: (Not supplied with dryer)
Refer to your "Use and Care Guide" for information about
accessories available for your dryer.
/4" nut driver Tape measure
recommended)
Pliers
4