Table of Contents
Advertisement
Available languages
Available languages
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed here.
Tools needed for all installations:
Flat-blade screwdriver
Level
Utility knife
Tin snips (new vent
installations)
Tape measure
INSTALLATION REQUIREMENTS
Adjustable wrench that
opens to 1" (25 mm) or
hex-head socket wrench
Vent clamps
Caulking gun and
compound (for installing
new exhaust vent)
1/4"( 6 mm) nut driver
(recommended)
Pliers
Tools needed for gas installations:
8" (203 mm) or 10"
(254 mm) pipe wrench
Pipe-joint compound
resistant to LP gas
Parts supplied (all models):
Leveling legs (4) for models
with riser
Parts supplied (steam models):
"Y" connector
5' (1.52 m) Inlet Hose
Remove parts package from dryer drum. Check that all parts
are included.
Parts needed: (Not supplied with dryer)
Check local codes. Check existing electrical supply and venting.
See "Electrical Requirements" and "Venting Requirements" before
purchasing parts.
Mobile home installations require metal exhaust system hardware
available for purchase from the dealer from whom you purchased
your dryer. For further information, please refer to the "Assistance
or Service" section in your "Use and Care Guide."
Optional Equipment: (Not supplied with dryer)
Refer to your "Use and Care Guide" for information about
accessories available for your dryer.
8" (203 mm) or 10"
(254 mm) adjustable wrench
(for gas connections)
Leveling legs (4) for models
without riser
2' (0.6 m) inlet hose
Rubber washer
5
Advertisement
Table of Contents
