Modifiers; End Of Cycle Signal; Heated Dryer Rack - Kenmore 8519320 Use & Care Manual

Air Dry Press END of CYCLE SIGNAL to adjust the sound level or turn off
Use the Air Dry Modifier for items that require drying without heat the signal.
such as rubber, plastic and heat-sensitive fabrics. This table NOTE: When WRINKLE GUARD _"_ is selected and the End of
shows examples of items that can be dried using Air Dry. Cycle Signal is on, a tone sounds every five minutes until the
clothes are removed, or WRINKLE GUARD '_ ends.
Type of Load Time*
(Minutes)
Foam rubber - pillows, padded bras, stuffed toys 20 - 30
Plastic - Shower curtains, tablecloths 20 - 30
Rubber-backed rugs 40 - 50
Olefin, polypropylene, sheer nylon 10 - 20
* Reset cycle to complete drying, if needed.
The dryer rack is shipped in place in your dryer. Remove and
discard any packing material before use.
Use the TUMBLE FREE
TM
Heated Dryer Rack for items that you
do not want to tumble dry, such as sweaters. When you use the
heated dryer rack, the heated air inside the dryer flows in a
concentrated pattern to allow efficient and uniform drying. Use
Timed Dry to select the desired time.
To use the heated dryer rack:
Do not remove the lint screen.
When using Air Dry
• Check to see that coverings are securely stitched.
• Shake and fluff pillows by hand periodically during the cycle.
• Dry item completely. Foam rubber pillows are slow to dry.
NOTE: Air Dry is not available with Auto Dry Cycles.
You can change Auto Dry and Manual Cycles, Options and
Modifiers any time before pressing Start.
• Three short tones sound if an unavailable combination is
selected. The last selection will not be accepted.
1. Open dryer door.
2. Place dryer rack over the bottom of the dryer door opening.
Rest the back wire on the dryer back ledge. Push down on
the frame front to secure over lint screen.
Changing Cycles after pressing Start
1. Press PAUSE/CANCELtwice.
2. Select the desired cycle and options.
3. Press and hold START. The dryer starts at the beginning of
the new cycle.
NOTE: If you do not press Start within 5 minutes of selecting the
cycle, the dryer automatically shuts off.
Changing Options and Modifiers after pressing Start
You can change an Option or Modifier anytime before the
selected Option or Modifier begins.
1. Press PAUSE/CANCEL once.
3. Place wet items on top of the rack. Allow space around items
for air to circulate. The rack does not move, but the drum will
rotate. Make sure items do not hang over the edges or
between rack grille.
2. Select the new Option and/or Modifiers.
3. Press and hold START to continue the cycle.
NOTE: If you happen to press Pause/Cancel twice, the program
clears and your dryer shuts down. Restart the selection process.
4. Close the door,
End of Cycle Signal
The End of Cycle Signal produces an audible sound when the
drying cycle is finished. Promptly removing clothes at the end of
the cycle reduces wrinkling.
• HIGH
5.
6.
Select TIMED DRY and MORE TIME or LESS TIME. Reset
time as needed to complete drying. Refer to the following
table.
Select the desired temperature setting to match the fabrics in
your load by pressing TEMPERATURE. Items containing
foam, rubber, or plastic must be dried on a clothesline or by
using the Air Dry temperature setting. Refer to the following
table.
• LOW
• OFF
7. Start the dryer,
To remove the dryer rack, lift it straight up and out of the dryer,
NOTE: Check the lint screen and remove any lint accumulated
from items dried on the rack.
END of CYCLE SIGNAL
18