Installing A Board Support Panel - NEC HX4000 User Manual

Installing a Board Support Panel

To remove the board support panel:
1. Observe the safety and ESD precautions listed at the
beginning of this chapter.
2. Remove the top cover, see Removing the Top Cover,
earlier in this Chapter.
3. Loosen the two thumb screws on the board support
panel (Figure 5-3).
4. Remove the board support panel by pulling it out of
the chassis. Set the board support panel aside.
Figure 5-3. Removing Board Support Panel
A
B
1. Place the board support panel in position so that the
rear edge of the processor or memory board fits snug
against the rubber cushion on the support panel
(Figure 5-3).
2. Secure the support panel with its two thumb screws.
3. Reinstall the top cover.
Removing board support panel
A Support panel
B Thumb screws (two total)
(structural details of panel not
shown here)
Upgrades and Options
5-11