Bios; Updating The Bios; Resetting The Cmos Nvram - NEC HX4600 User Manual

BIOS

The following contains procedures for updating your BIOS .

Updating the BIOS

You should use this procedure when you receive a BIOS FLASH diskette from
your service representative. Update the system BIOS as follows.
Note:
you want to save the event log contents, run the Event Log
Reader Utility.
1. Insert a bootable DOS diskette into Drive A and power up the system.
2. Remove the MS-DOS diskette and insert the BIOS FLASH diskette into
Drive A.
3. Enter PHLASH and press
4. After the system reboots, load the default values by pressing
setup. At the Exit Menu, select GET DEFAULT VALUES.
5. Clear the event log by selecting CLEAR EVENT LOG at the Server Menu.
Press space bar to change NO to YES and press
CHANGES & EXIT and press

Resetting the CMOS NVRAM

Reset the CMOS NVRAM as follows.
1. Power off the system and remove the panels as described in chapter 5 of this
guide.
2. Move the CMOS Clear jumper 11A to ENABLE (1-2). See Figure 3-3 and
Table 3-4).
3. Turn the system on and wait for the POST to complete. This automatically
reprograms the CMOS NVRAM to the default settings.
4. Power off the system.
5. Move the CMOS Clear jumper 11A back to DISABLE (2-3).
6. Replace the panels and power on the system.
7. Run the Setup Utility to configure your system.
3-22 Configuring Your System
This procedure clears the event log contents. If
.
Enter
Enter
. Select SAVE
Esc
to continue. The system reboots.
to enter
F2