Clearing and Changing the Password
Clear and change the password as follows.
1. Power off the system and remove the panels as described in the Upgrades
and Options chapter.
2. Move the Password Clear jumper 11A1 to ENABLE (1-2). See Figure 3-3
and Table 3-4.
3. Power on the system and wait for POST to complete. This automatically
clears the old password.
4. Power off the system.
5. Move the Password Clear jumper 11A1 back to DISABLE (2-3).
6. Replace the panels and power on the system.
7. To specify a new password run the Setup Utility.
Configuring Your System 3-23