NEC HX4600 User Manual page 99

Figure 4-18. Removing Blank Panel Tray
Figure 4-19. Removing Side Rails
6. Remove the device from its protective wrapper and place it on an antistatic surface.
Record the drive model and serial number in the equipment log.
7. Set any device jumpers or switches on the device. Refer to the installation
procedures that come with the device.
Note:
SCSI termination resistors for the 5 1/4-inch devices must
be installed in the last SCSI device of the daisy chain cabling
(bottom media bay D). All other 5 1/4-inch devices must have
terminators removed.
8. Using the four screws supplied with the drive, reinstall the side rails just removed
from the blank panel tray (see Figure 4-20, A).
Upgrading Your System 4-31