Hard Disk Drive Activity Led Does Not Light - NEC LE2200 User Manual

Hard Disk Drive Activity LED Does Not Light

If you have installed one or more hard disk drives in
your system, check the following:
Are the power and signal cables to the hard disk
drive properly installed?
Is the optional disk controller board fully seated in
the system board connector?
Are all relevant switches and jumpers on the hard
disk drive and controller board set correctly?
Are the jumpers on the system board set correctly?
Is the hard disk controller properly configured in
the RCU?
Is the hard disk activity LED cable connector
plugged into the optional controller board, if
present?
If you received error messages, refer to the Error
Messages section for information about error messages.
If you did not receive error messages, run the RCU to
make sure that the hard disk drive is configured with
the correct parameters. For information about running
the RCU, refer to the Configuring Your System chapter.
If the problem persists, there may be a problem with
the hard disk drive, the optional controller board,
system board, drive signal cable, or LED connector.
Contact your service representative for assistance.
5-17
Problem Solving