Updating The Bios - NEC LE2200 User Manual

Updating the BIOS

To update the system BIOS:
Note: This procedure clears the event log contents. If
you want to save the event log contents, run the Event
Log Reader Utility.
1. Using the EXPRESSBUILDER CD-ROM, create the
BIOS FLASH diskette.
2. Insert a bootable DOS diskette into Drive A and
power up the system.
3. Insert the BIOS FLASH diskette into Drive A.
4. Enter PHLASH and press ENTER.
5. After the system reboots, load the default values by
pressing F2 to enter setup. At the Exit Menu, select
GET DEFAULT VALUES.
6. Clear the event log by selecting CLEAR EVENT LOG
at the Server Menu. Press space bar to change NO to
YES and press ESC. Select SAVE CHANGES & EXIT
and press ENTER to continue. The system will
reboot.
If the procedure fails, perform the following steps and
then retry the Update BIOS procedure.
1. Turn off the system and remove the panels as
described in the Upgrades and Options chapter.
2. Ensure the FLASH Code jumper J6A is set to pins 1-
2 to enable updates to the BIOS (see Figure 3-1).
3. Replace the panel and power up the system with the
BIOS FLASH diskette inserted in Drive A
Configuring Your System
3-29