Installing A Rack-Mountable System; Managing Cables - NEC Express5800/320Ma Installation Manual

Before you install the system, make sure that the site has been prepared as described
in the Express5800/320Ma: Site Planning Guide.
To install your rack-mountable system, see:
•
Figure
•
"Safety Notices" on page 1-5
•
"Managing Cables" on page 2-1
•
"Installing a Rack-Mounted System" on page 2-2
•
"Installing the System Components" on page 2-11
Tools required:
•
A #2 Phillips-head screwdriver
•
A flat-head screwdriver or a cage-nut insertion and extraction tool

Managing Cables

When routing cables within the cabinet, keep all power cords separate from peripheral
and communication cables as much as possible. For example, route all power cords on
one side of the cabinet and all peripheral and communications cables on the other side
of the cabinet, using the cable management rings on your cabinet to constrain the
cords and cables.

Installing a Rack-Mountable System

1-2, which identifies the components of a rack-mountable system
and "Safety Considerations" on page 1-6
Installing a Rack-Mountable System
Chapter 2
2-
2-1