NEC Express5800/320Ma Installation Manual page 65

! C A U T I O N
If you do not enable boot monitoring after you perform the
IPL, fault-tolerance of the system is compromised.
7. Express5800/320MaAfter the system has restarted, log on again. The Post
Installation Check window appears for several minutes.
8. The Post Installation Check Tool dialog box appears and automatically runs. This
tool verifies that the upgrade was successful and that the system is restored to full
operation. Click Exit to dismiss the Post Installation Check Tool dialog box. See
"IPL Considerations" on page 6-2
Installation Check tool.
9. The message box 'Has the NEC ExpressCluster Web service been set up?' may
appear during the NEC ExpressCluster SRE installation, but will automatically
disappear after 5 seconds. DO NOT take action to this prompt, or the system may
appear to hang.
10. If you are attaching any EMC
a. Download and install the latest QLogic
Windows 2003.
– See the Express5800/320Ma: PCI Adapter Guide for information about the
U525 or U526 PCI adapters that provide connectivity to EMC CLARiiON
and Symmetrix
extracting, and installing the driver.
– See Attaching an EMC CLARiiON AX100 Storage System to an
Express5800/320Ma System for information about the U531 Optical Fibre
Channel PCI Adapter that provides connectivity to AX100 storage
systems, and instructions for downloading, extracting, and installing the
driver.
b. Install the EMC PowerPath
EMC.
c. Connect the system to the storage enclosure. If the storage enclosure is part
of a storage area network (SAN), add the system to the SAN.
11. Configure your system. In particular, do the following:
for a description of the file created by the Post
®
storage systems to the system, do the following:
®
®
storage systems, and instructions for downloading,
®
software. See the PowerPath documentation from
Installing Express5800/320Ma System Software
The Post-IPL Procedure
Fibre Channel drivers for
®
6-11