Setting Up Your System; Ports On The System - NEC Express5800/320Ma Installation Manual

To set up your system, see:
•
"Ports on the System" on page 4-1
•
"Connecting a Monitor, Mouse, and Keyboard" on page 4-3
•
"Connecting the System to Ethernet Networks" on page 4-4
•
"Connecting the Modem" on page 4-5
•
"Connecting an External USB Floppy Disk Drive" on page 4-6
•
"Connecting the System to Electrical Power" on page 4-6

Ports on the System

The ports are located at the rear of the system, as shown in Figures 4-1and 4-2. Refer
to these illustrations as you connect cables and power cords to the system.
Your system may contain PCI adapters that require cables. Your system contains a
half-height PCI adapter slot in each CPU- I ⁄ O enclosure. In addition, the system may
contain two full-height PCI adapter slots (expansion slots).
Figure 4-1
half-height PCI adapter slots.
Figure 4-2
half-height slots and in each expansion PCI adapter slot.
When you receive your system from the manufacturer, PCI adapters that were ordered
at the same time the system was ordered are installed. If you need to install PCI
adapters in the system, see the Express5800/320Ma: PCI Adapter Guide and the
Express5800/320Ma: Operation and Maintenance Guide.
shows the rear of a pedestal system that contains PCI adapters in the
shows a rack-mounted system that contains PCI adapters in the standard

Setting Up Your System

Setting Up Your System
Chapter 4
4-
4-1