Installing A Pedestal System - NEC Express5800/320Ma Installation Manual

Before you install the system, make sure that the site has been prepared as described
in the Express5800/320Ma: Site Planning Guide
To install your pedestal system, see
pedestal system, "Safety Notices" on page
page 1-6.
Tools required: None
To install the system in a pedestal case
1. Install the modem assembly.
!
C A U T I O N
Make sure that the modem is powered off. You can install
the modem assembly if the system is turned off and no
power cords are connected to the system. If you must
install the modem assembly while the system is in
operation, see the Express5800/320Ma: Operation and
Maintenance Guide.
a. At the rear of the system, remove the metal plate from the backplane.
b. Insert the modem assembly into its slot on the backplane, as shown in
Figure 3-1.
c. Secure the modem assembly in place by tightening the thumbscrew.

Installing a Pedestal System

Figure 1-2, which identifies the components of a
1-5, and "Safety Considerations" on
Installing a Pedestal System
Chapter 3
3-
3-1