Centre-Channel Options; Connecting Dsp5500 - Meridian DSP5500 User Manual

Connecting DSP5500

Sto.
The DSP5500 will respond with the store message
Recalling settings in Setup
The Store key operates normally as a recall when there is no tone cursor
displayed.
1. Wait for a volume, track or time display on the master
2. Press Store
Limitations of storing
Tilt and bass settings are stored by each source independently. Phase,
axis and boundary settings are stored for all sources, and the last setting
stored is that used for all sources.

Centre-channel options

Using the centre position control
To change the centre position setting:
1. Press the w or e menu key until the centre position display shows.
The master display will momentarily show
C.P. 1
2. Press either the n or s menu key. Choose a setting 1–4 following the
guidelines in the handbook for the Centre speaker.
Using the centre tilt-offset control
To change the centre tilt offset:
1. Press the w or e menu key until the centre tilt-offset display shows.
The master display will momentarily show
C.t. 0
2. Press either the n or s menu key. Choose a setting following the
guidelines in the handbook for the Centre speaker.
Note When customisation is complete, switch the power off, wait for 3
seconds, then switch it on again to restore normal operation and to save
what you have done.
Four types of connection must be made to the DSP5500:
power (see page 12)
digital audio (see page 44)
communications (see page 45)
RS232 to a computer (see page 47)
You will need to plan the connections with the installation you wish to
achieve in mind. It is best to do this while deciding where to put the
DSP5500s, as this decision may affect the positioning of the rest of your
system, and the way in which you connect it. The decision as to which
speaker should be master is also dependent on both positioning and
connections.
The following sections will explain in detail the options open to you.
Remember that your Meridian dealer is chosen for his expertise in this
area. If in doubt, you can always refer to him.
Customising using Setup
DSP5500 User Guide
41