Kenmore 15831 Use & Care Manual page 19

Dishwasher is not operating proper_y
PROBLEM... CAUSE... SOLUTION...
Dishwasher does not
run or stops during a
cycme
Door not closed
Wrong cycle selected
No or improper power sup-
plied to dishwasher
Motor stopped due to overload
No water supplied to
dishwasher
Make sure door is cJosed and secureJy latched.
Refer to the "Cycles" section, page 12.
Check to see if household fuse or circuit breaker is
blown or tripped.
Motor will automaticalJy reset itself within a few minutes.
if it does not restart, calJ for service.
Check to see if shut=off valve (if instalJed) is turned on.
Dishwasher will
not fill
Dishwasher seems
to run too long
Water remains
in dishwasher
Overfill protector stuck
Water supplied to dish=washer
is not hot enough
Cycle not finished
Check to see if the overfill protector moves up and down
freely. Press down to release.
it is normal for the dishwasher to run longer while heating
water. Refer to the "Water temperature tips" section,
page 11.
oA delay will occur in the main wash if the Water Heat
option is selected.
oThree delays will occur if the Pots & Pans cycle is
selected.
o The final rinse will automatically delay until the water
temperature reaches 135°F (57°C).
Wait for the cycle to complete.
Detergent remains in
covered section of
dispenser
White residue
appears on front
of access panel
Cycle not finished
Detergent has lumps
Bottom rack in backwards
Wait for the cycle to complete.
Replace with dry, lump-free detergent.
Refer to the "Parts and Features" section, page 3 and
reinstall rack if necessary.
Odor in the
dishwasher
Too much detergent
was used
Brand of detergent
developing excess foam
Refer to the "Using the detergent dispenser" section,
page 10.
Try a different brand to reduce foaming and eliminate
buildup.
Dishes only washed every
2=3 days
Run a Quick Rinse cycle at least once or twice a day
until full load is accumulated.
Plastic smell of new dishwasher Run a vinegar rinse, as described on the next page.
Condensation on Excessive moisture from vent in Dishwasher console should be aligned with countertop.
kitchen counter dishwasher console Refer to Installation Instructions for more information.
Dishes are not cleaned corn letel
Food soil left Improper loading Refer to the "Loading Your Dishwasher" section,
on dishes pages 7=9.
Water temperature is too low Use the Water Heat option. If needed, turn home water
heater up to ensure water entering dishwasher is 120°F
(49°C) minimum. Refer to the "Water temperature tips"
section, page 11.
Use of incorrect, too little, Use recommended dishwasher detergents only. Refer
or ineffective detergent to the "Using the detergent dispenser" section, page 10.
Never use less than one tablespoon per load. Detergent
must be fresh to be effective. Always store detergent in
a cool, dry area.
18