Advertisement
Consumer Defined Control
Setting Temperature
Display-
Fahrenheit
or Celsius
The _
and CleanFlex
pads control the Fahrenheit
or Celsius temperature
display
modes. The oven control can be programmed
to display
temperatures
in Fahrenheit
or Celsius. The oven has been preset at the factory
to display
in Fahrenheit.
Note: both
ovens will be changed
at the same time.
iNSTRUCTiONS
PRESS
DISPLAY
To change
dlsplav
from
Fahrenheit
to Ceislus or Celsius to
Fahrenheit
1.
Press _
and hold for 7 seconds. A beep will sound° "550" will
appear
"BROIL" will flash in the display
(Fig. 1). After 6 seconds
a beep will be heard and "F" (Fig. 2) or "C" (Fig. 3) will appear
in
the display.
If "F" appears,
the display
is set to show temperatures
in
Fahrenheit
(Fig. 2). If "C" appears,
the display
is set to show
temperatures
in Celsius (Fig. 3).
2.
Press Flex to switch between
Fahrenheit
or Celsius display
modes.
Clean
The display
will show either "F" (Fig. 2) or "C" (Fig. 3).
to accept
the change
or press "-_
to reject the change.
3.
Press
for 7seconds
Fig. 1
Fig. 2
Flex
Cban
Fig. 3
Setting Accent Light
Your range includes a decorative
Accent
Light centered
horizontally
across touch-sensitive
control
panel. The Accent
light
comes with a theatre
style intensity feature
that slowly increases brightness
at turn on and slowly fades when turning
off.
When the Accent
light is off° the light is in automatic
mode. This means the Accent
light will turn on automatically
when an
oven or Timer has been activated.
The Accent
light will turn off automatically
when these functions
are no longer active.
Accent
When the Accent
light is OFF, it may be turned ON by pressing
Lightonce. When the Accent
light has been manually
turned
Accent
on, it will remain
on until manually
turned off by pressing
Light again. The brightness
may also be adjusted.
INSTRUCTIONS
PRESS
DISPLAY
Example
- To adjust
the Accent
llght
brightness:
Accent
1.
Press and hold
Light until an acceptance
tone sounds (about 6
seconds)
2.
The default
setting of 100 wiJJappear
in the display
(See Fig. 4).
3.
Using the numeric
keypad° enter any digit from 0 to ]00
to
change
the brightness
level. Entering 0 (Fig. 5) will effectively
turn the Accent
light OFF until the brightness
level is adjusted
to a
higher level.
4.
Press _
to save the desired
brightness
setting.
Accent
Light
Value between
0 to 100
@
Fig. 4
Fig. 5
Operating
Oven Lights
The interior oven lights will turn ON when the oven door is opened.
Press _ to turn oven light ON an OFF whenever
the oven door is closed.
The interior oven lights are located on the rear wall of the oven interior and are covered
with a glass shield. The glass shield
protects
the bulb from high temperatures
and should always
be in place whenever
the oven is in use.
To replace
the interior oven lights, see Replacing oven lights in the Care and Cleaning
section.
19
Advertisement
