Advertisement
General Care & Cleaning
Removing
and Replacing
the Lift-Off
Oven Door
The door is heavy. For safe, temporary
storage,
lay the door flat
with the inside of the door facing
down.
D
Hinge
Fig. 2
door
Fig. 3
i
Roller
pin
- Hinge
arm
hook
To Remove Oven Door:
1.
Open oven door completely
(horizontal
with floor
- See Fig. 1).
2.
Puii the door hinge locks on both left and right door hinges down from the oven
frame completely
towards
the oven door (See Fig. 2). A tool such as a small
flat-blade
screwdriver
may be required.
3.
Firmly grasp both sides of oven door along the door sides (Do not use the oven
door handle
- See Fig. 3).
4.
Close the door to about
a 10 degree angle
as shown in Fig. 3.
5.
With the oven door in this position,
lift the oven door hinge arms away from
the roller pins located
on each side of the oven frame
(See Fig. 4).
To Replace
Oven Door:
1.
Firmly grasp both sides of oven door along the door sides (Do not use the oven
door handle
- See Fig. 3).
2.
Holding
the oven door at the same angle as the removal
position,
seat the hook
of the hinge arm onto the roller pins located
on each side of the oven door
frame (See Fig. 4). Also, seat the notch of the hinge arm onto the bottom
of the
slot at the same time you seat the hook. The hook and notch of the hinge arms
must be fully seated onto the roller pins.
3.
Fully open the oven door (horizontal
with floor - See Fig. 1).
4.
Push the door hinge locks up towards
and into the oven frame on both left and
right oven door hinges (See Fig. 2) to the locked
position.
5.
Close the oven door.
Speclal
Door Care instructions
= Most oven doors contain glass that can break.
Read the following
recommendations:
1.
Do not close the oven door until aii the oven racks are fully in place.
2.
Do not hit the glass with pots, pans, or any other object.
3.
Scratching,
hitting, jarring
or stressing the glass may weaken
its structure
causing an increased risk of breakage
at a later time.
\
Hinge
arm
notch
Slot bottom
Fig. 4
Changing
the Oven
Light
On some models
an interior oven light will turn automatically
when the oven
door is opened.
The oven light may be turned
on when the door is closed
by
pushing
___ located
on the control
panel.
On some models,
the lamp
is covered
with a glass shield held in place
by a wire holder. THE GLASS SHIELD MUST BE
iN PLACE WHENEVER
THE OVEN
IS iN USE.
To replace
the light bulb:
CAUTION:
BE SURE THE OVEN
iS COOL.
1.
Turn the power
off: at the main source.
2.
Wear
a leather-faced
glove for protection
against
possible
broken
glass.
3.
Replace
bulb with 40-watt
appliance
bulb only.
4.
For models with glass shield,
press holder
on one side to release
glass shield,
change
bulb and be sure to replace
the glass shield.
38
Advertisement
