Advertisement
Setting Surface Controls Cco.t,d)
Operating
Single
Radiant
Surface
Elements
The cooktop
has 3 SINGLE radiant
surface elements
(figure 1): the RIGHT REAR position,
the LEFT REAR position
and the LEFT FRONT position.
To Operate
the Single Radiant Surface Elements:
1.
Place correctly sized cookware
on the radiant
surface
element.
2.
Touch and hold the _
pad for the desired
element
position
until a beep is heard.
The display
will show " -- "
Note: If no further pads are touched within 10 seconds the request to power the element
ON will clear.
3.
Touch Hi pad once to turn ON the power level to HI. Touch Lo pad once for Lo power level
(See Figure 2).
4.
Each touch of the Hi or Lo pad will decrease
or increase
the power level from 9.0 through
3.0 by .5 increments.
Simmer power levels between
3.0 and 1.2 will decrease
or increase by
.2 increments.
Lo is the lowest power level available.
.
Note: The power level may be adjusted
at any time while the element
is ON.
When cooking
has been completed
touch the _o_F,_pad once to turn the element
OFF.
Each surface element provides a constant amount of heat at each setting. A glowing
red surface
heating
area extending
beyond
the bottom
edge of the cookware
indicates the cookware
is
too small for the surface
heating
area.
Note: The Hot Surface message will be displayed
on the control
panel as soon as the element
is hot and will remain ON until the heating
surface area has cooled
sufficiently.
Radiant surface elements may appear
to have cooled after they have been turned
off. The glass surface may still be hot and burns may occur if the glass surface is touched
before
it has cooled
sufficiently.
Do not place plastic items such as salt and pepper shakers, spoon holders or p[astlc
wrappings
on fop of the range when
it is in use. These items could
melt or ignite. Pothoiders,
towels or wooden
spoons could catch fire if placed
too close to the surface
elements.
Figure
1
Single
Elements
//
Hi
Lo
Figure 2
I0
Advertisement
