Advertisement
Setting Surface Controls (co.t,d)
Operating
the Triple Surface Elernenf
The cooktop
is equipped with a Triple radiant surface element
located
at the right front cooktop
position (Figure 1). Indicator
lights on the control panel at that position
are used to indicate
what portions
of the Triple radiant
element
will heat. The O
light indicates that only the inner element
will heat. The @
light indicates that both inner and middle
elements will heat
The @
light
indicates
that all 3 portions of the
element
togethen
will heat. You may switch between
all of these different
settings
at any time during
cooking.
Figure 1
To Operate
the Triple
Surface
Element:
1.
Place correctly
sized cookware
on the radiant
surface
element.
2.
Touch and hold the @
pad for the Triple element position
until a beep is heard. The display
will show " - - "
Figure 2
.
Note: If no further pads are touched
within 10 seconds the
request to power the element
ON will clean
Select the
0
(See Figure 2), @
(See Figure 3) or @
(See Figure 4) to heat by pressing the _
pad
elements
once, twice or three times (Figures 4 show indicator
lights with ALL 3 elements
selected).
4.
Touch Hi pad once to turn ON the power level to HI (See Figure 5). Touch Lo
pad once for Lo.
5.
Each touch of the Hi or Lo pad will decrease
or increase
the power level from
9.0 through 3.0 by .5 increments. Simmer power levels between
3.0 and 1.2 will
decrease
or increase
by .2 increments.
Lo is the lowest power level available.
Note: The power level may be adjusted
at any time while the element is ON.
Each surface
element
provides
a constant
amount
of heat
at each setting.
Irregular
glowing
effect
is depending
of the element
design and doesn't affect
performance
of the element.
A glowing
red surface
heating
area extending
beyond
the bottom
edge of the cookware
indicates
the cookware
is too small
for the surface heating
area.
6.
When cooking
has been completed
touch the _
pad once to turn the element
OFF.
Figure 3
Figure 4
Note: If no element
size is chosen when the Triple element is turned ON, the control
will default
to the inner coil only. See recommended
surface
cooking
settings.
Note:
The Hat Surface message will be displayed
on the control
panel as soon as
the element
is hot and will remain
ON until the heating
surface
area has cooled
sufficiently.
Radiant surface elements
may appear
to have cooled after they have
been turned off. The glass surface
may siJJJ be hat and burns may occur if the glass
surface
is touched
before it has cooled
sufficiently.
Do nat place aluminum
fall or plastic items such as saJt and pepper
shakers, spoon holders
or pJasflc wrappings
on fop of the range when if is in use.
These items could melt or ignite.
Pothoiders,
towels or wooden
spoons could
catch
@
Hot Surface
000
0
®
Figure 5
fire if placed
too close to the surface elements.
11
Advertisement
