Kenmore 665.16512 Use & Care Manual page 14

Use this rinse cycle for _R
_°IC h rinsing dishes, glasses,
UU
and silverware that will
not be washed right Do not use detergent
away. with this cycle.
Wash Rinse Main Rinse Final Dry Time Water
Wash Heated (min} Usage
Rinse (gaUL)
• 10 t.8-2.7/
6.8-10.2
*If the incoming water temperature is less than the
recommended temperature or food soils are hearvy, the cycle
will automatically compensate by adding time, heat and water
as needed.
You can add an item anytime before the main wash starts. Open
the door and check the detergent dispenser. If the cover is still
closed, you can add items.
To add items
1. Lift up the door latch to stop the cycle. Wait for the spraying
action to stop before opening the door.
2. Open the door. If the detergent dispenser cover is still closed,
add the item.
3. Close the door firmly until it latches. The dishwasher resumes
the cycle after about a 5-second pause.
Anytime during a cycle, press
CANCEL/DRAIN glows. The dishwasher starts a 2-minute drain (if
needed). Let the dishwasher drain completely. The light goes off
when the dishwasher finishes the drain.
To stop the drain
You can press CANCEL/DRAIN again to stop the drain
immediately. Remember to drain the dishwasher before starting a
new cycle.
To clear the indicators
Press CANCEL/DRAIN before starting the dishwasher to clear all
options and cycles.
During the first minute of a cycle
1. Press a new cycle and/or options.
2. Checkthedetergentdispensers. Theymustbefilledproperly
for the new cycle.
After the first minute of a cycle
1. Press
CANCEL/DRAIN glows. Your dishwasher starts a 2-minute
drain (if needed). Let the dishwasher drain completely.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
3. Close the door.
4. Press a new cycle and/or options.
5. Press START.
You can customize your cycles by pressing an option. If you
change your mind, press the option again to turn the option off.
Select a different option if desired.
You can change an option anytime before the selected option
begins. For example, you can press an unheated drying option
any time before drying begins.
Press START to use the same cycle and option(s) as the previous
wash cycle.
NOTE: If the last cycle you completed was a rinse cycle, when
you press Start, the dishwasher runs the last full wash cycle and
options.
Hi Temp Scrub
Select this option to heat the water during parts of the cycle. Hi
Temp Scrub heats the water to 145°F (63°C) in the main wash.
Heating the water helps improve washing results. Hi Temp Scrub
is useful when loads contain baked-on food.
This option adds heat and wash time to the cycle. When Hi Temp
Scrub is used with the Pots Pans cycle, water is also added to
the cycle.
NOTE: Hi Temp Scrub is an option with Smart Wash, Pots Pans
and Normal Wash.
Sani Rinse
Select this option to raise the water temperature in the final rinse
to approximately 155°F (68°0). Sani Rinse adds heat and time to
the cycle. This high temperature rinse sanitizes your dishes and
glassware in accordance with NSF/ANSl Standard 184 for
Residential Dishwashers. Certified residential dishwashers are
not intended for licensed food establishments.
NOTE: Sani Rinse is an option with SmartWash, Pots Pans, and
Normal Wash. Only these sanitization cycles have been designed
to meet the NSF/ANSI requirements.
14