Download  Print this page

Electrical Requirements - Kenmore 2220693 Use & Care Manual

Hide thumbs


Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded
electrical supply is required. It is recommended
that a separate
circuit serving only your refrigerator be provided. Use an outlet
that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn the control (Thermostat,
or Freezer Control depending on the model) to OFF and then
the refrigerator from the electrical source. When you
are finished, reconnect the refrigerator to the electrical source
and reset the control (Thermostat, Refrigerator or Freezer Control
depending on the model) to the desired setting.
To remove the base grille:
1. Open both refrigerator doors.
Place hands along the ends of the grille, with your thumbs
along the top. Push in with your thumbs and pull up on the
NOTE: Be sure to refasten the Tech Sheet behind the base grille
after cleaning.
To replace the base grille:
1. Open the doors.
Line up the grille support tabs with the metal clips,
Push the grille firmly to snap it into place.


Table of Contents

  Related Manuals for Kenmore 2220693

This manual is also suitable for:

Elite 106 series