3Com 9000 SX User Manual page 118

8-8 C 8: IP U
HAPTER
Table 8-3 RIP Configuration Commands (continued)
Command
enable rip splithorizon
enable rip triggerupdate
config rip add {vlan <name> | all}
config rip delete {vlan <name> | all} Disables RIP on an IP interface. When RIP is disabled on the
config rip garbagetime {<delay>}
config rip routetimeout {<delay>}
config rip rxmode [none | v1only |
v2only | any] {vlan <name> | all}
config rip txmode [none | v1only |
v1comp | v2only] {vlan <name> | all}
config rip updatetime {<delay>}
disable rip
disable rip aggregation
(continued)
R
NICAST OUTING
Description
Enables the split horizon algorithm for RIP. Default setting is
enabled.
Enables triggered updates. Triggered updates are a
mechanism for immediately notifying a router's neighbors
when the router adds or deletes routes, or changes the
metric of a route. The default setting is enabled.
Configures RIP on an IP interface. If no VLAN is specified,
then all is assumed. When an IP interface is created, per
interface RIP configuration is enabled by default.
interface, the parameters are not reset to their defaults.
Configures the RIP garbage time. The default setting is 120
seconds.
Configures the route timeout. The default setting is 180
seconds.
Changes the RIP receive mode for one or more VLANs.
Specify:
none — Drop all received RIP packets.
v1only — Accept only RIP version 1 format packets.
v2only — Accept only RIP version 2 format packets.
any — Accept both version 1 and version 2 packets.
If no VLAN is specified, the setting is applied to all VLANs.
The default setting is "any".
Changes the RIP transmission mode for one or more VLANs.
Specify:
none — Do not transmit any packets on this interface.
v1only — Transmit RIP version 1 format packets to the
broadcast address.
v1comp — Transmit version 2 format packets to the
broadcast address.
v2only — Transmit version 2 format packets to the RIP
multicast address
If no VLAN is specified, the setting is applied to all VLANs.
The default setting is "v2only".
Changes the periodic RIP update timer. The default setting
is 30 seconds.
Disables RIP.
Disables the RIP aggregation of subnet information on a
RIP version 2 interface.