3Com 9000 SX User Manual page 116

8-6 C 8: IP U
HAPTER
Table 8-1 Basic IP Commands
Command
enable bootp {vlan <name> | all}
enable bootprelay
enable ipforwarding {vlan <name> | all}
enable ipforwarding broadcast {vlan <name> | all} Enables forwarding IP broadcast traffic for
config bootprelay add <ipaddress>
config bootprelay delete [<ipaddress> | all]
config iparp add <ipaddress> <mac_address>
config iparp delete <ipaddress>
disable bootp vlan [<name> | all]
disable bootprelay
disable ipforwarding {vlan <name> | all}
disable ipforwarding broadcast {vlan <name> | all} Disables routing of broadcasts to other
clear iparp [<ipaddress> | vlan <name> | all]
(continued)
R
NICAST OUTING
Table 8-1 describes the commands used to configure basic IP settings
on the Switch.
Description
Enables the generation and processing of
BOOTP packets on a VLAN to obtain an IP
address for the VLAN from a BOOTP server.
The default setting is enabled for all VLANs.
Enables the forwarding of BOOTP and
Dynamic Host Configuration Protocol (DHCP)
requests.
Enables IP routing for one or more VLANs. If
no argument is provided, enables routing for
all VLANs that have been configured with an
IP address. The default setting for
ipforwarding is disabled.
one or more VLANs. If no argument is
provided, enables broadcast forwarding for
all VLANs. To enable, ipforwarding must be
enabled on the VLAN. The default setting is
enabled.
Adds the IP destination address to forward
BOOTP packets.
Removes one or all IP destination addresses
for forwarding BOOTP packets.
Adds a permanent entry to the ARP table.
Specify the IP address and MAC address of
the entry.
Deletes an entry from the ARP table.
Specify the IP address of the entry.
Disables the generation and processing of
BOOTP packets.
Disables the forwarding of BOOTP requests.
Disables routing for one or more VLANs.
networks.
Removes dynamic entries in the IP ARP
table. Permanent IP ARP entries are not
affected.