Voice-Assisted Arm/Disarm Module; Introduction; Access Codes; How Do I Use It - Paradox DGP2-641 System Manager's Manual

Con gratula ti ons o n ch oosing the Par adox In To uch Vo ice -Assisted A rm/Disar m Modu le (APR3 -ADM2). InTou ch
turn s any tou ch -tone te leph one into a keypad . With InTouch, you can now a rm o r disar m your Digiple xNE Sa botage -
P roof High -Secur ity S ystem as well as acti va te or de acti va te yo ur InTouch's ou tp ut all from you r telep hone . Using
d eta iled voice pro mpts to g uide your way, th e InTou ch is as simp le as pi cking u p yo ur te leph one.
InTou ch uses you r Dig iplexNE User Access Code to g rant you access to you r Digi plexNE syste m. Th e Use r Access
Cod e entere d o n yo ur Digipl exNE syste m keypad is th e sa me you wou ld use to en te r o n yo ur te leph one.
S TE P 1:P ick up you r telep hon e an d d ial the te leph one numbe r of the line that your In To uch is con nected to. The
InTou ch will no w ask yo u to en ter you r Dig iplexNE User Acce ss Code .
S TE P 2:E nter yo ur Digiple xNE User Access Cod e.
If your Digiplex NE s yste m is programm ed t o acc ept v ariable code lengths, you must pres s the
[ #] key aft er e nte ring y our Us er Acc ess Code.
S TE P 3:K eys [1 ] to [ 8] on you r te lepho ne re presen t ar eas 1 to 8. To ar m o r disarm your Digi plexNE system, press
the de sir ed area 's numb er o n yo ur tele pho ne. This will tog gle th e a rea's arming sta te from a rmed to
d isa rmed an d vice versa (refer to se ction 1 6.0 on page 2 2).
S TE P 4:To activate or de activate the InTouch's ou tpu t, pre ss the [#] key an d th en the [0] key (re fe r to section 1 6.0
o n page 22 ).
14.1

WHEN ACCESSING YOUR INTOUCH...

• If you are using an answering machine or service, call the InTouch, hang up after one ring, wait between 10 and 255
seconds (depending on how Intouch was programmed by your Installer), and then call the InTouch again to access it.
14.2

WHEN ARMING OR DISAR MING...

• You will only be able to arm or disarm areas that your User Code has access to.
• If you were to arm an area with an open zone, DigiplexNE will Force arm the area. This will only happen with User
Access Codes that have the Force arming feature enabled.
14.3

WHEN ACTIVATING OR DEACTIVATING A PGM...

• Your InTouch's output can be used to turn on lights, open or close a garage door and much more. Ask your installer
about this useful feature.
• If the InTouch's o utput is not operational, you will not be able to activate or deactivate the output.

Voice-Assisted Arm/Disarm Module

Operating Instructions

11.0 INTRODUCTION

12.0 ACCESS CODES

13.0 HOW DO I USE IT?

14.0 THINGS YOU SHOULD KNOW

LCD Keypad 21