Surface Burners; When Self-Cleaning Your Oven - Kenmore SENS-A-CLEAN 665.75842 Use & Care Manual

SURFACE BURNERS
PROBLEM
The burner fails to light
The burner flames are
uneven
The burner flames lift off
the ports, are yellow, or
are noisy when turned off
The burner makes a • The burner is wet from washing. Let it dry.
popping noise when on
CAUSE/SOLUTION
• The control knob is not set correctly. Push in the control knobs before turning
them. Make sure the control knob is turned to the LITE position. (See p. 7.)
• A household fuse has blown or a circuit breaker has been tripped.
• The burner ports may be clogged. Clean them with a straight pin. (See p. 42.)
• Make sure Cooktop Lockout has been cancelled. (See p. 14.)
• There is a power outage.
• The burner ports may be clogged. Clean them with a straight pin. (See p. 42.)
• The burner caps may not be positioned properly. (See p. 42.)
• The burner needs cleaning. (See pp. 41, 42.)
• The burner may be damaged. Contact a Sears Service Center to check
the burner.
• If propane gas is being used, the range may have been converted
improperly. Contact a Sears Service Center.
WHEN SELF-CLEANING YOUR OVEN
PROBLEM CAUSE/SOLUTION
The Self-Cleaning cycle • START/ENTER has not been pressed.
will not work • A delay start has been set. Wait for the start time to be reached or cancel
and reset the control.
• The door is not closed all the way.
continued on next page
iii!!iii_
47