Assembling The Surface Burners; Checking Ignition Of Surface Burners - Kenmore 721.7603 Series Installation Manual

ASSEMBLING THE SURFACE
BURNERS
CAUTION
DO NOT operate the burners without all parts in
place.
Place the burner caps and heads on the cooktop. Make sure
that the caps and heads are placed in the correct locations.
There is one small, one medium, one large and one extra
large burner head and cap.
Center Burner
(on some models)
Oval (Center) Burner
Head/Cap Assembly
Medium
burner
head and
cap
Front of range
Large burner
head and cap
Hole
Electrode
Make sure the hole in the burner head is positioned over the
electrode.
CHECKING IGNITION OF
SURFACE BURNERS
ELECTRIC IGNITION
Select a top burner knob and simultaneously push in and
turn to the "LITE" position. You will hear a clicking sound
indicating proper operation of the spark module.
Once the air has been purged from the supply lines,
burner should ignite within 4 seconds. After burner ignites,
rotate knob out of the "LITE" position. Try each burner in
succession until all burners have been checked.
(on some models)
qUALITY OF FLAMES
Medium burner
head and cap
The combustion quality of burner flames needs to be
confirmed visually.
Small burner
head and cap
(on some (on some
models) models)
Extra large burner
head and cap
With LP gas, some yellow tipping on outer cones is normal.
INSTALLING THE RANGE
A Yellow flames – Call for service.
B Yellow tips on outer cones –
This is normal for LP gas
C Soft blue flames –
This is normal for natural gas
11