Kenmore SENS-A-CLEAN 665.75842 Use & Care Manual page 37

SETTING THE CONTROLS
5. Press any pad to remove "End" and bring back YOU SEE
time of day; or open door, at which time "door"
will be displayed. Then close door and time of
day will appear in display window.
6, After the oven is cool, wipe off any residue or ash
with a damp cloth or sponge. If needed, touch up
spots with a mild abrasive cleanser or cleaning
sponge,
1. Press SENS-A-CLEAN.
SEnS setting will automatically determine the
length of cleaning time. Maximum clean time is
472 hours and minimum is 2 hours.
(when Pressing any pad)
YOU SEE
(when opening the door)
NOTE: Make sure the clock is set to the correct
time of day. (See "Setting the clock" in the "Using
Your Range" section, p. 13.)
PRESS YOU SEE
2. (Optional) If you would prefer to set the soil level
yourself, you can set Light, Average or Heavy soil.
You can scroll through all 4 settings (SEnS, SoilL,
SoilA, and SoilH) continuously by pressing the
SENS-A-CLEAN keypad.
Press SENS-A-CLEAN twice, SoilL (for light soils)
will appear on the display.
Press SENS-A-CLEAN three times, SoilA (for
average soils) will appear on the display.
Press SENS-A-CLEAN four times, SoilH (for heavy
soils) will appear on the display.
SoilL will clean for approximately 2-2V2 hours,
SoilA for 3-3V2 hours, and SoilH for 4-472 hours.
PRESS YOU SEE
(example shows light soil
setting)
3. Press DELAY START.
PRESS YOU SEE
DELAY
START
4. Set the start time.
Press the HOUR/MIN (_k) or (V) pad(s) until the
desired time of day to start the SENS-A-CLEAN
Self-Cleaning cycle shows on the display.
PRESS
HOUR MIN
YOU SEE
(example for 12:30 start time)
continued on next page 37