Kenmore 79053 Service Manual page 36

17. The vent control handle must be straightened
before the decorative front is attached. Pull down
part ® to align with part ®.
18. FRONT INSTALLATION
• Hook upper tabs of front grille into slots on the
cabinet top. (See Figure 96)
• Push front grille towards the cabinet in order to
snap side tabs into the cabinet. (See Figure 96)
• Open the filter door. (See Figure 97)
• Tighten the TYPE A screw @ through the front
gdlle. (See Figure 97)
• Close filter door. (See Figure 98)
19. If AIR CONDITIONER is Blocked by Storm Win-
dow FRAME, add wood to clear frame as shown
in Figure 99, or remove storm window frame
while air conditioner is installed.
Vent Control Installation
Installing Bottom Rail Seal
Figure 95
Figure 96
• /
Front Installation
@
3.4 AIR CONDITIONER REMOVAL
Turn the air conditioner off, disconnect the power
cord, remove the window locking bracket and the
screws installed through the top and bottom of the
side curtains. Save all parts for later reinstallation.
Close the side curtains. Keeping a firm gdp on the
air conditioner, raise the sash, and carefully tilt the
air conditioner backward, draining any condensed
water. Lift the air conditioner from the window.
Remove the sash seal from between the windows.
• Air conditioners covered in this manualpose an exces-
sive weighthazard.Two or more people are needed to
moveand installthe unit.
To preventinjuryor strain,useproperlifting] and carry-
ingtechniqueswhen movingunit.
• When handlingthe air conditioner, b e carefulto avoid
cutsfromshaq:)metalfins on frontand rear coils.
_,_.Make sure air conditioner d oes not fall duringremoval.
Figure 97 FrontInstallation
Figure 98 FrontInstallation
g
Stormwindowframe--_
or otherobstnJction
Wood block in area --
of leveling support
Figure 99
1 V2_min
thickness as
, along
entirestool.
Fastenwithtwo
nailsor screws.
---36---