Kenmore 79053 Service Manual page 35

8. Select the position that will place the sill supports
near the outer most point on sill (See Figure 88).
Attach the sill supports to the cabinet track hole in
relation to the selected position using TYPE A
screw @.
9. Place the sill supports with the cabinet on the win-
dow sill's selected position.
10. The cabinet should be installed with a very slight
tilt (about 1/4") downward toward the outside
(See Figure 89).
Adjust the bolts and the nuts of sill supports to
level the cabinet.
(_)Screw(Type A)
_ g
Cabinet
OUTDOOR
fNDOOR
Figure 88
Figure 89
Track
11. Attach the cabinet to the window stool by ddving
the TYPE B screws ® through the front angle
into window stool.
12. Pull the window sash down behind the upper
guide. Pull each side curtain fully to each sash
track.
13. Attach each side curtain to the window sash
using TYPE C screws (_ (See Figure 91)
14. Attach the window locking bracket _ with TYPE
C screw ® (See Figure 92)
Figure 90
Figure 91
Front Angle
Screw(Type B) (_
Sill Support (_)
Screw
.,.(Type C)(_
Screw
15. Slide the chassis into the cabinet.
(See Figure 93)
CAUTION: For security purpose, reinstall
screws at cabinet's sides.
Figure 92
16. Cut the foam seal ® to the proper length and
insert between the upper window sash and the
lower window sash. (See Figure 94)
Cord
Screw
Figure 93
Screw
Figure g4
--35--