Entering Remote Control Codes; Remote Control Codes For Integra/Onkyo Components Connected Via - Integra DTR-30.2 Instruction Manual

Entering Remote Control Codes

You'll need to enter a code for each component that you
want to control.
1
Look up the appropriate remote control code in
the separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
2
While holding down Remote Mode to which you
want to enter a code, press and hold down Dis-
play (about 3 seconds).
The Remote indicator lights.
Note
• Remote control codes cannot be entered for Receiver
and Zone 2.
• Only TV remote control codes can be entered for TV.
• Except for Receiver, TV and Zone 2, remote control
codes from any category can be entered as Remote
Mode. However, these buttons also work as input selector
buttons (➔ 23), so choose a Remote Mode that corre-
sponds with the input to which you connect your compo-
nent. For example, if you connect your CD player to the
CD input, choose TV/CD when entering its remote control
code.
3
Within 30 seconds, use the number buttons to
enter the 5-digit remote control code.
The Remote indicator flashes twice.
If the remote control code is not entered success-
fully, the Remote indicator will flash once slowly.
Note
• The remote control codes provided are correct at the time of
printing, but are subject to change.
Remote Control Codes for Integra/
Onkyo Components Connected via
Integra/Onkyo components that are connected via
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1
Make sure the Integra/Onkyo component is con-
nected with an cable and an analog audio
cable (RCA).
See "Connecting Integra/Onkyo
for details (➔ 19).
2
Enter the appropriate remote control code for
Remote Mode.
• BD/DVD
• TV/CD
• Port
See the previous section for how to enter remote
control codes.
Note
• When using a cassette tape deck connected via
and hold TV/CD to switch to TAPE.
3
Press Remote Mode, point the remote controller
at the AV receiver, and operate the component.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want to
control an Integra/Onkyo component that's not connected
via
• BD/DVD
30627:
Integra/Onkyo DVD player without
• TV/CD
71817:
Integra/Onkyo CD player without
11807:
Integra/Onkyo TV
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, use the follow-
ing remote control codes:
32900:
are
Integra/Onkyo Blu-ray Disc player
32901:
Integra/Onkyo HD-DVD player
70868:
Onkyo MD recorder
71323:
Onkyo CD recorder
82990:
Components"
Onkyo Universal Port Option Dock
Note
• If you connect a cassette tape deck to the TV/CD IN jack, or
connect an RI Dock to the to the TV/CD IN or VCR/DVR IN or
GAME IN jacks, for
Display accordingly
31612:
Integra/Onkyo DVD player with
71327:
Integra/Onkyo CD player with
42157:
Onkyo cassette tape deck with
81993:
Onkyo Universal Port Option Dock
, use the following remote control codes:
to work properly, you must set the Input
(➔ 25).
, press
En
71