Entering Remote Control Codes - Integra DTR-70.3 Instruction Manual

12
When you searched for the model, a message
"Successful" will appear. Now the transfer is
successful!
Go to step 15.
When you did NOT search for the model, push any
key (except for arrow buttons and Enter) to see if
the component responds.
Tip
• The numbers in [ / ] mean the order of the candidate code
and the total number of codes for the brand.
13
If you can control component, press Receiver, use
/ to select "Works", and then press Enter.
If you cannot control component, press Receiver,
use / to select "Doesn't work (Retry)" and press
Enter.
The next code appears. Repeat from step 11.
14 Press Enter to transfer the determined code.
Input sensor
15° off center
(Left/Right/Up/Down)
15
Press Enter.
You'll return to the category selection menu. Press
Setup to end the remote mode setup.
Transmitter
15
15
Approx.
16 ft. (5 m)

Entering Remote Control Codes

You'll need to enter a code for each component that you
want to control.
1
Look up the appropriate remote control code in the
separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
2
While holding down the Remote Mode to which
you want to assign a code, press and hold down
Display (about 3 seconds).
The Remote Mode button lights.
Note
• Remote control codes cannot be entered for Receiver and
Zone.
• Only TV remote control codes can be entered for TV.
• Except for Receiver, TV and Zone, remote control codes
from any category can be assigned to the Remote Mode.
However, these buttons also work as input selector buttons
(➔ page 23), so choose a Remote Mode that
corresponds with the input to which you connect your
component. For example, if you connect your CD player to
the CD input, choose TV/CD when entering its remote
control code.
3
Within 30 seconds, use the number buttons to enter
the 5-digit remote control code.
Remote Mode button flashes twice.
If the remote control code is not entered successfully,
Remote Mode button will flash once slowly.
Note
• Though the provided remote control codes are correct at the time
of printing, they are subject to change.
En
79