Integra DTR-30.2 Instruction Manual page 63

wide speakers (6.1/7.1), such as Dolby Digital EX, DTS-ES,
THX Select2 Cinema, Dolby Pro Logic IIz height, and
Audyssey DSX™ are unavailable.
• When the "Front High/Front Wide/Zone 2" setting is set to
"Zone 2" and the input selector of Zone 2 is selected, power con-
sumption on standby mode slightly increases.
Controlling Zone 2 with the Remote
Controller
1
Press Zone2 and then press On/Standby.
Zone 2 turns on, the Zone 2 indicator lights.
2
To select an input source for Zone 2, press Zone2,
followed by an input selector buttons.
To select AM or FM, press the Tuner input selector
repeatedly.
(North American models) You can also select SIR-
IUS.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2. The same FM/AM radio sta-
tion will be heard in each room.
3
To turn off Zone 2, press Zone2 followed by On/
Standby.
Note
• To control Zone 2, you must press the remote controller's
Zone2 first.
Adjusting the Volume for Zone 2
■
Operating with the remote controller
Press Zone2, and then use VOL / .
■
Operating on the AV receiver
Use Zone 2 Level / .
Muting Zone 2
■
Operating with the remote controller
Press Zone2 followed by Muting.
Tip
• To unmute, press Zone2 followed by Muting again.
• Zone 2 can also be unmuted by adjusting the volume.
On/Standby
Zone2
Input Selector buttons
Muting
VOL /
Adjusting the Tone and Balance of Zone 2
Zone 2 Tone
,
1
On the AV receiver, press Zone 2.
2
Press the AV receiver's Tone repeatedly to select
"Bass", "Treble" or "Balance".
3
Use + and – to adjust the Bass, Treble or Balance.
• You can boost or cut the Bass or Treble from –10dB to
+10dB in 2 dB steps.
• You can adjust the balance from 0 in the center to +10dB
to the right or +10dB to the left in 2 dB steps.
Note
• Only analog input sources are output by the ZONE 2 PRE OUT
jacks and FRONT HIGH OR FRONT WIDE OR ZONE 2
SPEAKERS L/R speaker terminals. Digital input sources are
not output. If no sound is heard when an input source is selected,
check if it's connected to an analog input.
• While Powered Zone 2 is being used, listening modes that
require surround back speakers or front high speakers or front
wide speakers (6.1/7.1), such as Dolby Digital EX, DTS-ES,
THX Select2 Cinema, Dolby Pro Logic IIz height, and
Audyssey DSX™ are unavailable.
• While Zone 2 is on, functions will not work.
• You cannot select different AM or FM radio stations for your
main room and Zone 2. The same FM/AM radio station will be
heard in each room. For example, if you have an FM station for
the main room, that station will also be used in Zone 2.
• The Zone 2 level, balance, and tone functions have no effect on
the ZONE 2 PRE OUT jacks when the "Zone 2 Out" setting is
set to "Fixed" (➔ 62).
En
63