Integra DTR-30.2 Instruction Manual page 13

Connecting the Speaker Cables
Screw-type speaker terminals
Strip 1/2" to 5/8" (12 to 15 mm) of
insulation from the ends of the
speaker cables, and twist the bare
wires tightly, as shown.
Using Banana Plugs (North American models)
• If you are using banana plugs, tighten the speaker terminal before inserting the banana plug.
• Do not insert the speaker code directly into the center hole of the speaker terminal.
The following illustration shows which speaker should be connected to each pair of terminals. If you're using only one
surround back speaker, connect it to the SURR BACK OR FRONT HIGH OR FRONT WIDE L terminals.
Front high Front high
right speaker/ left speaker/
Front wide Front wide
right speaker left speaker
Note
• The front wide speakers can also be connected to the FRONT HIGH OR FRONT WIDE OR ZONE 2 SPEAKERS
terminals. When doing so, set "Front High/Front Wide/Zone 2" in Speaker Setup to "Front Wide" (
• The front high or front wide speakers can also be connected to the SURR BACK OR FRONT HIGH OR FRONT
WIDE SPEAKERS terminals. When doing so, set "Surr Back/Front High/Front Wide" in Speaker Setup to "Front
High" or "Front Wide" (
1/2" to 5/8"(12 to 15 mm)
Surround back
Surround back
left speaker
right speaker
➔
).
46
Surround right Surround left
speaker speaker
Front right Front left
speaker speaker
Center
speaker
➔
).
46
En
13