Integra DTR-30.2 Instruction Manual page 77

Zone 2
■
There's no sound
Only components connected to analog inputs can be
played in Zone 2.
■
The Zone 2 speakers produce no sound
Powered Zone 2 cannot be used if "Speakers Type
(Front)" is set to "Bi-Amp".
To use the Zone 2 speakers, you must set the "Front
High/Front Wide/Zone2" setting to "Zone2".
Others
■
The sound changes when I connect my
headphones
When a pair of headphones is connected, the listen-
ing mode is set to Stereo, unless it's already set to
Stereo, Mono or Direct.
■
The speaker distance cannot be set as required
In some cases, corrected values suitable for home
theater use may be set automatically.
■
How do I change the language of a multiplex
source
Use the "Multiplex" setting on the "Audio Adjust"
menu to select "Main" or "Sub".
■
The functions don't work
To use , you must make an
analog audio connection (RCA) between the compo-
nent and AV receiver, even if they are connected dig-
itally.
■
The functions System On/Auto Power On and
Direct Change don't work for components
connected via
These functions don't work when Zone 2 is turned
on.
■
When performing "Audyssey 2EQ
Correction and Speaker Setup", the
measurement fails showing the message
"Ambient noise is too high.".
This can be caused by any malfunction in your
speaker unit. Check if the unit produces normal
sounds.
■
The following settings can be made for the
composite video input
You must use the buttons on the unit to make these set-
tings.
1. While holding down the input selector button for the input
source that you want to set, press Setup.
2. Use / to change the setting.
3. Press the input selector button for the input source that you
want to set when you've finished.
• Video Attenuation
This setting can be made for the BD/DVD, VCR/DVR,
CBL/SAT, Game, or AUX input.
—
46
62
—
—
48
19
connection and an
19
®
Room
—
If you have a games console connected to the composite
video input, and the picture isn't very clear, you can
attenuate the gain.
Video ATT:OFF: (default).
Video ATT:ON: Gain is reduced by 2 dB.
The AV receiver contains a microcomputer for signal
processing and control functions. In very rare situations,
severe interference, noise from an external source, or
static electricity may cause it to lockup. In the unlikely
event that this happens, unplug the power cord from the
wall outlet, wait at least five seconds, and then plug it
back in again.
Mono or Direct is not responsible for damages (such as
CD rental fees) due to unsuccessful recordings caused
by the unit's malfunction. Before you record important
data, make sure that the material will be recorded cor-
rectly.
Before disconnecting the power cord from the wall out-
let, set the AV receiver to Standby.
En
77