Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
#2 Phillips and flat-blade
Adjustable wrench that
opens to 1 in. (2.5 cm) or
9/16in. open-end wrench
Caulking gun and
(for adjusting dryer feet)
new exhaust vent)
1¼in. nut driver or socket
Wood block (for leveling)
Ruler or measuring tape
Tin snips (for new vent
Wire stripper (direct wire
Remove parts package from the washer basket. Check that all
parts were included.
1. Water inlet hoses (2)
2. Inlet hose flat washers (4)
3. Front leveling feet with nuts (2)
4 Shipping strap (not in parts bag, see
"Remove Shipping Strap")
5 Drain hose
6 Yellow, single wire hose clamp
7. Silver, double-wire
Check local codes, electrical supply and venting, and read
"Electrical Requirements" and "Venting Requirements"
Mobile home installations require
Metal exhaust system hardware available for purchase from
your local Sears store or Sears Service Center.
Parts listed are available from your local Sears store or Sears
Service Center. Please reference the service numbers located on
the back page of this manual.
If You Have
You Will Need to Buy
Laundry tub or
Sump pump system (if not already
standpipe taller than
96 in. (2.4 m)
1 in. (2.5 cm)
2 in. (5 cm) diameter to 1 in. (2.5 cm)
diameter standpipe adapter, Part
Standard 26 gaL (76 L) 34 in. (86.4 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
Siphon break, Part Number 285320,
additional drain hose, Part Number
285702 and connector kit,
Part Number 285442
Drain hose too short
Drain hose, Part Number 285664 and
connector kit, Part Number 285442
Lint clogged drain
Drain protector, Part Number 367031
2 longer water fill hoses:
beyond reach of fill
6 ft (1.8 m) Part Number 76314,
10 ft (3.0 m) Part Number 350008
materials and vapors, such as
gasoline, away from dryer.
Failure to do so can result in death, explosion,
You will need
A location that allows for proper exhaust installation. See
A separate 30 amp circuit.
A grounded electrical outlet located within 2 ft (61 cm) of
either side of the laundry center. See "Electrical
A sturdy floor to support the laundry center weight (laundry
center, water and load) of 566 Ibs (226.8 kg).