Installation Requirements; Tools And Parts; Location Requirements; Installation Instructions - Kenmore Laundry Tower Use And Care Manual

Tools and Parts

Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Required
Phillips screwdriver
⁹⁄₁₆" (14 mm) open-end
wrench (for leveling leg
locknuts)
Parts Supplied
Console
Screws (2)

Location Requirements

Your laundry tower can be installed freestanding or between your
washer and dryer. Proper installation is your responsibility.
Installation Clearances
The location must be large enough to allow the drawers to be
fully opened.
The console is an optional feature of your laundry tower. It allows
you to match the style of your laundry tower to that of a top-
loading washer, and it provides additional storage space.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
laundry tower.
Failure to do so can result in back or other injury.
1. Using two or more people, situate the laundry tower near its
final location. Open the drawers to remove any contents
stored inside.
2

INSTALLATION REQUIREMENTS

Level
Measuring tape
Brackets (2)
A
B
A. Console
B. Bracket

INSTALLATION INSTRUCTIONS

Install the Console (optional)

When you are installing your laundry tower between or next to
your washer and dryer, a spacing of 1" (2.5 cm) on the sides
of the laundry tower is recommended to reduce noise
transfer.
Additional spacing should be considered for ease of
installation and servicing.
Laundry Tower Dimensions
40 ⁷⁄₈
"*
(103.8 cm)
36" - 38"†
(91.4 -
96.5 cm)
¹⁄₂
43 "
(110.4 cm)
*Includes leveling feet
**Includes drawer front
†Adjust the leveling feet to match the height of your washer and
dryer.
2. Using a Phillips screwdriver, remove the 2 outside screws
from the back of the laundry tower top panel and discard
them.
A. Outside screws
10"
(25.4 cm)
³⁄₄
25 "**
¹⁄₂
(65.4 cm)
13 "
(34.3 cm)
A