Installation Instructions; Tools And Parts; Alternate Parts; Location Requirements - Kenmore 24-inch wide laundry center washer-gas dryer Use And Care Manual

INSTALLATION
INSTRUCTIONS
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
Tools needed:
• 8in. or lOin. adjustable • Knife
wrench (for gas
connections) • Safety glasses
• Flat-blade screwdriver • Duct tape
• Adjustable wrench that • Pipe-Joint compound
opens to 1 in. (2.5 cm) or resistant to L.R gas
9/16in. open-end wrench • Caulking gun and
(for adjusting dryer feet) compound (for installing
• Level new exhaust vent)
• ¼ in. nut driver or socket • Gloves
wrench • Pliers
• Wood block (for leveling) • Ruler or measuring tape
• Tin snips(new vent
installation)
Parts supplied
Remove parts package from the washer basket. Check that all
parts were included.
5
1. Water inlet hoses (2)
2. Inlet hose flat washers (4)
3. Rear leveling legs (2)
4. Front leveling legs (2)
7
5. Plastic strap
6. Drain hose
7. Yellow, single wire hose clamp
8. Silver, double-wire hose clamp
Parts needed:
Check local codes and with gas supplier, check existing gas
supply, electrical supply and venting, and read "Electrical
Requirements," "Gas Supply Requirements" and "Venting
Requirements" before purchasing paris.
Mobile home installations require:
• Mobile Home Installation Kit. To order, call your local Sears
store or Sears Service Center. For further information, please
reference the service numbers located on the back page of
this manual. Ask for Part Number 346764.
• Metal exhaust system hardware available for purchase from
your local Sears store or Sears Service Center.
Parts listed are available from your local Sears store or Sears
Service Center. Please reference the service numbers located on
the back page of this manual.
If You Have You Will Need to Buy
Laundry tub or Sump pump system (if not already
standpipe taller than available)
96 in. (2.4 m)
1 in. (2.5 cm) 2 in. (5 cm) diameter to 1 in. (2.5 cm)
diameter standpipe diameter standpipe adapter, Part
Number 3363920
Overhead sewer Standard 20 gal. (76 L) 34 in. (86.4 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
Floor drain Siphon break, Part Number 285320,
additional drain hose, Part Number
285702 and connector kit,
Part Number 285442
Drain hose too short Drain hose, Part Number 285664 and
connector kit, Part Number 285442
Lint clogged drain Drain protector, Part Number 367031
Water faucets 2 longer water fill hoses:
beyond reach of fill 6 ft (1.8 m) Part Number 76314,
hoses 10 ft (3.0 m) Part Number 350008
L }cst ©_'1_,@ (;_,, y@ '_sx? yl1:,s
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Failure to do so can result in death, explosion,
or fire.
You will need
• A location that allows for proper exhaust installation. A gas
laundry center must be exhausted to the outdoors. See
"Venting Requirements."