Download  Print this page

Installation Instructions; Tools And Parts; Alternate Parts; Location Requirements - Kenmore 8873 - 24 in. Space Saver Laundry Center Use And Care Manual

24-1nch wide1120-volt laundry center washer- electric dryer
Hide thumbs

Advertisement

INSTALLATION
INSTRUCTIONS
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
Tools needed:
Flat-blade screwdriver
Knife
Adjustable wrench that
Safety glasses
opens to 1 in. (2.5 cm) or
9/16in. open-end wrench
Duct tape
(for adjusting dryer feet)
Caulking gun and
Level
compound
(for installing
new exhaust vent)
¼ in. nut driver or socket
wrench
Gloves
Wood block (for leveling)
Pliers that open to 1 9/18
in. (3.95 cm)
Tin snips (newvent
installations)
Parts supplied
Remove parts package from the washer basket. Check that all
parts were included.
O_1
_20
3
_
4
Parts listed are available from your local Sears store or Sears
Service Center. For more information, please reference the
service numbers located on the back page of this manual.
If You Have
You Will Need to Buy
Laundry tub or
Sump pump system (if not already
standpipe taller than
available)
96 in. (2.4 m)
1 in. (2.5 cm)
2 in. (5 cm) diameter to 1 in. (2.5 cm)
diameter standpipe
diameter standpipe adapter, Part
Number 3363920
Overhead sewer
Standard 20 gal. (76 L) 34 in. (86.4
cm) tall drain tub or utility sink and
sump pump (available from local
plumbing suppliers)
Floor drain
Siphon break, Part Number 285320,
additional drain hose, Part Number
285702 and connector
kit,
Part Number 285442
Drain hose too short
Drain hose, Part Number 285664 and
connector
kit, Part Number 285442
Lint clogged drain
Drain protector, Part Number 367031
Water faucets
2 longer water fill hoses:
beyond reach of fill
6 ft (1.8 m) Part Number 76314,
hoses
10 ft (3.0 rn) Par[ Number 350008
L }cst
©_'t _,@ (;_,, y@ '_sx? yl1:,s
1, Water inlet hoses (2)
2. Intet hose flat washers (4)
3. Rear leveling legs (2)
4. Front leveling legs (2)
5. Plastic strap
& Drain hose
7. Yellow, single wire hose clamp
8. Silver, double-wire
hose clamp
Parts needed
Check local codes, electrical supply and venting, and read
"Electrical Requirements" and "Venting Requirements"
before
purchasing parts.
Mobile home installations require
Metal exhaust system hardware available for purchase from
your local Sears store or Sears Service Center.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Failure to do so can result in death, explosion,
or fire.
You will need
A location that allows for proper exhaust installation. See
"Venting Requirements."
A 120-volt, 60-Hz., AC-only, 15- or 20-amp circuit.
A grounded electrical outlet located within 2 ft (61 cm) of
either side of the laundry center. See "Electrical
Requirements."
A sturdy floor to support the laundry center weight (laundry
center, water and load) of 500 Ibs (226.8 kg).

Advertisement

Table of Contents
loading

  Related Manuals for Kenmore 8873 - 24 in. Space Saver Laundry Center