INSTALLATION
INSTRUCTIONS
Check that you have everything necessary for correct installation.
Proper installation is your responsibility.
Tools needed
•
8 in. or lOin. adjustable
•
Knife
wrench (for gas
connections)
•
Safety glasses
•
Flat-blade screwdriver
•
Duct tape
•
Adjustable wrench that
•
Pipe-joint compound
opens to 1 in. (2.5 cm) or
resistant to L.R gas
9/16in. open-end wrench
•
Caulking gun and
(for adjusting dryer feet)
compound
(for installing
•
Level
new exhaust vent)
•
1¼in, nut driver or socket
•
Gloves
wrench
•
Pliers
•
Wood block (for leveling)
•
Scissors
•
Ruler or measuring tape
•
Tin snips (new vent
installation)
Parts supplied
Remove parts package from the washer basket. Check that all
parts are included.
O
3
1
Parts listed are available from your local Sears store or Sears
Service Center. Please reference the service numbers located on
the back page of this manual.
If You Have
You Will Need to Buy
Laundry tub or
Sump pump system (if not already
standpipe taller than
available)
96 in. (2.4 m)
1 in. (2.5 cm)
2 in. (5 cm) diameter to 1 in. (2.5 cm)
diameter standpipe
diameter standpipe adapter, Part
Number 3363926
Overhead sewer
Standard 20 gal. (76 L) 34 in. (86.4 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
Floor drain
Siphon break, Part Number 285326,
additional drain hose, Part Number
285702 and connector kit,
Part Number 285442
Drain hose too short
Drain hose, Part Number 285664 and
connector kit, Part Number 285442
Lint clogged drain
Drain protector, Part Number 367031
Water faucets
beyond reach of fill
hoses
2 longer water fill hoses:
6 ft (1.8 m) Part Number 76314,
16 ft (3.0 m) Part Number 350008
4
6
5
1. Water inlet hoses (2)
2Jnlet hose flat washers (4)
3. Front leveling feet with nuts (2)
4. Shipping strap (not in parts bag,
see "Remove Shipping Strap")
5. Drain hose
6.Yellow, single wire hose clamp
7. Silver, double-wire
hose clamp
Parts needed
Check local codes and with gas supplier, check existing gas
supply, electrical supply and venting, and read "Electrical
Requirements",
"Gas Supply Requirements"
and "Venting
Requirements"
before purchasing parts.
Mobile home installations require
•
Mobile Home Installation Kit. To order, call your local Sears
store or Sears Service Center. For further information, please
reference the service numbers located on the back page of
this manual. Ask for Part Number 346764.
•
Metal exhaust system hardware available for purchase from
your local Sears store or Sears Service Center.