Home > Voip > Stun Configuration - D-Link 2Voice + 4SW VoIP Router DVG-1402S Manual

Home > VoIP > STUN Configuration
Simple Traversal of UDP
over NAT (STUN) − is a
protocol which enables a
VoIP device, such as this
router or an IP phone, to
detect the presence and
type of NAT behind which
the phone is placed. This
router supports STUN
and can intelligently
modify the private IP
address and port in its
SIP/SDP message by
using the NAT mapped
public IP address and port
through a series of STUN
queries against a STUN
server located on the
public Internet. This will
allow SIP signaling and
RTP media to
successfully traverse a
NAT without requiring any
configuration changes on
the NAT.
STUN is useful if you need to use the DVG-1402S behind a modem or router that
provides the connection to your ISP and then to the Internet and does not support
symetric NAT. You will need access to a STUN server on the Internet and its IP
address to use STUN on the DVG-1402S.
STUN State
STUN Server IP Address
STUN Server Port
STUN ReqInterval
STUN NAT Type
Use this drop-down menu to Enable or Disable STUN on the
router.
Enter the IP address of a STUN server in this field.
Enter the port number the STUN server will use in this field.
If you do not have any information as to the proper port
number, leave the default setting here.
This determines the amount of time, in seconds, between
STUN requests. If you do not have any information as to the
proper interval, leave the default setting here.
Displays the result of the STUN NAT examination.
22