Download Print this page
   

Advertisement

This product can be set up using Internet
Explorer or Netscape Navigator, 6.x or
above, with Javascript enabled
Before You Begin
You must have at least the following:
‧ A subscription with bundled service provider included in this package
‧ A Computer with a CD-ROM drive and an Ethernet port running a Windows
Ethernet based broadband modem
Check Your Package Contents
These are the items included with your purchase:
If any of the below items are missing, please contact your reseller.
©2005 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of
their respective holders. Software and specifications subject to change without notice. DVG-6008S FXO
VoIP Router
DVG-6008S FXO VoIP Router
Phone Cord
CAT5 Ethernet Cable
CD-ROM
12V DC Power Adapter
DVG-6008S
FXO VoIP Router
Using a power supply
with a different voltage rating
will damage this product and
void the warranty

Advertisement

   Also See for D-Link DVG-6008S

   Summary of Contents for D-Link DVG-6008S

  • Page 1: Before You Begin

    12V DC Power Adapter will damage this product and void the warranty ©2005 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of their respective holders. Software and specifications subject to change without notice. DVG-6008S FXO VoIP Router...

  • Page 2: Hardware Overview

    Hardware Overview Front Panel Power LED Indicates the unit is powered on. The Run LED will flash when performing a self- test/booting up and light solid green if the self-test or bootup fails. The Alarm LED will light solid red if the self-test or Alarm bootup fails.

  • Page 3: Rear Panel

    Rear Panel Line Ports Connect to your original telephone line on the wall jack with RJ-11 cable. LAN Port Connect to your Ethernet enabled computers using Ethernet cabling. WAN Port Connects to your broadband modem using an Ethernet cable. Reset This is used to reset the unit to the factory default settings.

  • Page 4

    Modem and Computer If your computer connects directly to a DSL or Cable modem and does not connect to a router, follow the steps below to install your DVG-6008S. For any other configuration, please refer to the user manual located on the CD-ROM.

  • Page 5

    Connecting the DVG-6008S directly to a Modem and Computer (continued) e. Attach one end of the Ethernet Cable provided in this package to the LAN or Ethernet Port on the Cable/DSL Modem. Attach the other end of the provided Ethernet Cable to the WAN Port of the DVG-6008S.

  • Page 6: Pppoe Configuration

    PPPoE Configuration Some Internet Service providers use PPPoE as their method of connecting clients. If you have a PPPoE connection, you must follow the steps below to complete the configuration of your hardware. If you are unsure of your connection type or do not know your username and password, please check with your Internet Service Provider.

  • Page 7

    Once the unit reboots you will see the message. Check to see if the status LED light goes from blinking green to solid green on the front panel of the DVG-6008S. The information found on the Device Information page is necessary for VoIP service...

Comments to this Manuals

Symbols: 0
Latest comments: