A Solid Blue Screen Appears; Other Software Problems; Memory Problems; Power Problems - Dell Latitiude E6500 Service Manual

1. Click Start ® Control Panel ® Programs ® Use an older program with this version of Windows.
2. In the welcome screen, click Next.
3. Follow the instructions on the screen.

A solid blue screen appears

Turn the computer off
If you are unable to get a response by pressing a key on your keyboard or moving your mouse, press and hold the power button for at least 8 to 10 seconds
(until the computer turns off), and then restart your computer.

Other software problems

Check the software documentation or contact the software manufacturer for troubleshooting information
Ensure that the program is compatible with the operating system installed on your computer.
l
Ensure that your computer meets the minimum hardware requirements needed to run the software. See the software documentation for information.
l
Ensure that the program is installed and configured properly.
l
Verify that the device drivers do not conflict with the program.
l
If necessary, uninstall and then reinstall the program.
l
Back up your files immediately
Use a virus-scanning program to check the hard drive, floppy disks, CDs, or DVDs
Save and close any open files or programs and shut down your computer through the Start menu

Memory Problems

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the
Regulatory Compliance Homepage at: www.dell.com/regulatory_compliance.
If you receive an insufficient memory message
Save and close any open files and exit any open programs you are not using to see if that resolves the problem.
l
See the software documentation for minimum memory requirements. If necessary, install additional memory (see
l
Reseat the memory modules (see Memory) to ensure that your computer is successfully communicating with the memory.
l
Run the Dell Diagnostics (see Dell™ Diagnostics).
l
If you experience other memory problems
Reseat the memory modules to ensure that your computer is successfully communicating with the memory (see Memory).
l
Ensure you are following the memory installation guidelines (see
l
Ensure the memory you are using is supported by your computer. For more information about the type of memory supported by your computer, see the
l
Setup and Quick Reference Guide for your computer on the Dell Support website at support.dell.com.
Run the Dell Diagnostics (see Dell™ Diagnostics).
l

Power Problems

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the
Replacing a Memory Module).
Replacing a Memory Module).