Removing The Coin-Cell Battery; Replacing The Coin-Cell Battery - Dell Latitiude E6500 Service Manual

Hide thumbs Also See for Latitiude E6500:

Technical manual (85 pages)

Setup and quick reference manual (72 pages)

Reviewer's manual (50 pages)

Table Of Contents

Table of Contents

Back to Contents Page

Coin-Cell Battery

Dell™ Latitude™ E6500 Service Manual

Removing the Coin-Cell Battery

Replacing the Coin-Cell Battery

Removing the Coin-Cell Battery

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the

Regulatory Compliance Homepage at: www.dell.com/regulatory_compliance.

CAUTION:

Disconnecting the coin-cell battery from the system board with no other power source causes the BIOS to reset to the default

configuration and sets the real-time clock to the build date. System configuration changes made in the BIOS by the user must be re-entered, and

the system clock must be set.

1. Follow the procedures in

Before Working on Your

2. Close the display and turn the computer over.

3. Remove the bottom of the base assembly (see

4. Pry up the coin-cell battery to release the double-sided adhesive tape on the bottom.

5. Lift the coin-cell battery out of the computer.

6. Disconnect the coin-cell battery cable from the system board.

battery cable connector

Replacing the Coin-Cell Battery

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the

Regulatory Compliance Homepage at: www.dell.com/regulatory_compliance.

1. Connect the coin-cell battery cable to the system board.

2. Insert the coin-cell battery into the computer.

3. If you are re-installing the old coin-cell battery, slide the battery under the tab, and press down to seal the tape on the bottom.

If you are installing a new coin-cell battery, remove the adhesive backing from the battery and slide the battery under the tab. Press to seal the tape on

the bottom.

4. Replace the bottom of the base assembly (see

5. Replace the battery (see

Replacing the

Computer.

Removing the Bottom of the Base

coin-cell battery

Replacing the Bottom of the Base

Battery).

Assembly).

Table of Contents