Recommended Paper - Lanier LW110 Operating Instructions Manual

Basics

Recommended Paper

• Standard paper sizes that can be used in this copier are shown below.
1
Metric version
A0
A1
A2
A3
A4
• When you make a copy on a non-standard size of paper, set the paper on the
Copy Paper Table.
• Weight of paper suitable for this copier: 51g/m
• Do not use the following kinds of paper or a paper jam might occur.
• Bent, folded, or creased paper
• Torn paper
• Perforated paper
• Non-smooth paper
• Slippery paper
• Thin paper that has low stiffness
• Do not make a copy on paper with any kind of coating, such as thermosensi-
tive paper, art paper, aluminum foil, and carbon paper.
A fault might occur.
• Do not use paper with strong curls at the edges or corners. (Curls rising more
than 5mm (1/4") or falling more than 20mm (3/4") over a 40mm (1.5") radius.)
• When you make copies on film, take out the copies delivered to the copy
guide one sheet at a time and place them on a flat surface.
• If copying to natural tracing paper (all pulp, translucent paper) at a relative
humidity of 35% or less
A If the paper was left out of its package for 5 minutes or more, remove the
first 1000mm (39.3") before copying.
B If copies come out wavy or with white spots, use translucent paper instead
of natural tracing paper.
C
Always keep the paper in a bag when not using it.
• Store the paper in a sealed polyvinyl bag if not used for a long period.
If it gets humid, paper will curl or wave which can cause a paper jam or part
of the image not to be copied.
8
Inch version
E (36" 48") K
D (24" 36") KL
KL
C (18" 24")
KL
B (12" 18")
K
A (9" 12")
Bypass Roll Feeder
K
KL
KL
KL
K
2
, 14lb to 134g/m
2
, 36lb.