Installation Information; Installation Requirements - KitchenAid KEBS278SSS - 27" Double Wall Oven Technical Manual

27" & 30" electric built-in double oven kebk276s series, kebk206s series, kebs277s series, kebs207s series, kebs278s series, kebs208s series
Hide thumbs Also See for KEBS278SSS - 27" Double Wall Oven:
Table of Contents

Advertisement

INSTALLATION INFORMATION

TOOLS AND PARTS
Gather the required tools and parts before start-
ing installation. Read and follow the instructions
provided with any tools listed here.
Tools needed
Phillips screwdriver
Measuring tape
Hand or electric drill (for wall cabinet instal-
lations)
• ˝ (25 mm) drill bit (for wall cabinet instal-
1
lations)
Level
Parts needed
UL listed or CSA approved conduit connec-
tor
UL listed wire connectors
Parts supplied
# 8-14 x 1
˝ screws - single oven (2), double
oven (4)
Bottom vent (supplied on some models)
Two # 8-18 x 3/8
˝ screws - bottom vent (sup-
plied on some models)
Check local codes. Check existing electrical
supply. See "Electrical Requirements," page
2-2. It is recommended that all electrical con-
nections be made by a licensed, qualified
electrical installer.
LOCATION REQUIREMENTS
Make sure you have everything needed for
correct installation. It is the responsibility of the
installer to comply with the installation clear-
ances specified in these instructions.
IMPORTANT: Observe all governing codes
and ordinances.
Cabinet opening dimensions that are shown
must be used. Given dimensions provide
minimum clearance with oven.

INSTALLATION REQUIREMENTS

Recessed installation area must provide
complete enclosure around the recessed
portion of the oven.
Grounded electrical supply is required. See
"Electrical Requirements," page 2-2.
Electrical supply junction box should be
located 3˝ (7.6 cm) maximum below the
support surface when the oven is installed
in a wall cabinet. A 1˝ (2.5 cm) minimum di-
ameter hole should have been drilled in the
right rear or left rear corner of the support
surface to pass the appliance cable through
to the junction box.
Oven support surface must be solid, level
and flush with bottom of cabinet cutout. Floor
must be able to support a total weight (double
built-in oven) of 287 lbs (108 kg).
Product Dimensions
27˝ (68.6 cm) and 30˝ (76.2 cm) Ovens
E
D
27" (68.6 cm) models
A. 25 5/16" (64.3 cm) max.
recessed width
B. 50 3/4 " (128.9 cm) max. overall
height
C. 26 3/4 " (67.9 cm) overall width
D. 23" (58.4 cm) max. recessed
depth
E. 49 9/16 " (125.9 cm) recessed
height
2-1
A
B
C
30" (76.2 cm) models
A. 28 5/16 " (71.9 cm) max.
recessed width
B. 50 3/4 " (128.9 cm) max. overall
height
C. 29 3/4 " (75.6 cm) overall width
D. 23" (58.4 cm) max. recessed
depth
E. 49 9/16 " (125.9 cm) recessed
height
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents