KitchenAid KEBS278SSS - 27" Double Wall Oven Technical Manual page 62

7. Bend the hidden bake element cover flaps
down as far as possible.
8. Using a single-edge razor blade, cut the
insulation blanket along the bracket edge
of the hidden bake element. Spread the
blanket apart so you can access the bracket
screws.
Cut Insulation
9. Remove the four screws from the hidden
bake element bracket.
Hidden Bake Element Bracket Screws
NOTE: When you remove the lower hidden bake
element, press down on the front edge of the
panel that is below the element so that it does
not interfere with the removal.
10. Pull the lower hidden bake element out and
remove it from the bottom of the oven.
11. Remove the two bracket screws from the
hidden bake element and remove the
bracket from the element.
REASSEMBLY NOTE: When you install the
replacement hidden bake element, press down
on the front edge of the panel that is below the
element so that it does not interfere with the
installation. When installed, the edge of the
panel should be below the element bracket so
that the bracket fits flush against the chassis.
Hidden Bake Element Bracket Screws
4-36