14. Remove the two screws from the door latch
assembly, pull the latch assembly back to
remove the latches from the cutouts, and
then lift and pull it forward so that you can
access the wiring.
15. Disconnect the wires from the assembly
as follows:
Latch motor = yellow & white
Door switch = brown (C) & orange (N.O.)
Latch switch = tan (C) & blue (N.O.)
YL
OR
BR
Latch Motor
Door Switch
Door Latch
Assembly Screws
WH
BU
TN
Latch Switch
16. To remove the latch motor, remove the
two motor screws from the bottom of the
assembly.
Latch Motor Screws
17. To remove the door or latch switch,
remove the bracket screw. NOTE: You
will have to remove the latch motor (in
step 15) to access the door or latch switch
Door Switch Screw
REASSEMBLY NOTE: After you reinstall the
door latch assembly in the oven, press the two
covers back down into place. Use a piece of
shipping tape and tape over the front edge of
the top cover to hold it in place and keep it from
vibrating during operation.
4-26
Latch Switch Screw